
In the advent of rising oil prices, choosing a vehicle based on engine type (petrol or diesel) might prove to be a very wise decision. Each engine type has its own advantages and disadvantages and your decision on what to purchase might well boil down to the vehicle’s purpose (i.e. for city driving, for hauling cargo, for heavy duty use, etc).
Let us compare a petrol and diesel engine and see how they stack up against each other, based on the facts:
Fuel Economy. Diesel has a higher energy density than petrol. This means it takes more petrol to equal the power output of diesel, therefore diesel engines are more efficient per liter of fuel burned. Diesel units also use about one third as much fuel at idle as petrol units. Over the years, this advantage could be significant, especially if you drive a lot of kilometers.
Noise/Vibration. Despite huge improvements in engine-noise technology in the past 10 years, diesel engines are still generally louder and shake more than their petrol counterparts. At idle, the clatter and shake of a diesel vehicle is clearly noticeable, while it’s tough to tell if the petrol engine is even running. Under low-speed acceleration, a diesel engine is still noisier.
Fuel Cost. Because diesel fuel is easier to refine, taking less time to get from crude oil to final product, it’s usually priced lower than petrol.
Short-Term Maintenance. Regular maintenance on a diesel engine is more costly, due to larger volume of oil in the engine and because fuel filters and water separators must be serviced more often. Modern petrol engines have an even bigger advantage thanks to extended service intervals on spark plugs, engine oil, etc.
Long-Term Maintenance and Durability. A diesel engine has an expensive initial cost but the flip side is its excellent durability. The average petrol engine is good for only around 200,000 kilometers before needing a rebuild and is not designed to constantly pull a heavy load. A diesel engine can go more than three times this amount before needing an overhaul.
Exhaust Smell/Emissions. Despite oil companies’ best efforts at producing diesel fuel with lower sulfur levels, burned diesel fuel still smells much worse than burned petrol. Beyond the smelly tailpipe, diesel lags behind petrol in the areas of Nitrogen Oxide emissions.
Power/Torque. Petrol engines have the advantage in horsepower, while diesel engines produce more torque. By design, petrol engines rev faster and are able to reach higher rpm peaks than diesel engines. This allows them to attain greater horsepower numbers.
However, for towing capacity and pulling force, a diesel owns a petrol engine. The torque advantage of a diesel vehicle is suited for pulling heavy loads, even up steep inclines. Because of the relatively high-compression ratio necessary to ignite the diesel fuel (17:1 diesel versus 9:1 petrol), a diesel engine makes all its torque and power low in the rev range.
Conclusion:
As stated in the beginning of this article, choosing between a petrol or diesel engine comes down to what you’ll do with the vehicle and where you live. If you want quick, quiet acceleration, rarely haul a heavy load, and you don’t plan on keeping the vehicle past 170,000 kilometers, you may want to consider a petrol engine. However, if you are going to use your vehicle for towing, value good fuel economy, and plan on racking up loads of mileage, diesel is for you.
20 users commented in " Petroleum Vs. Diesel: Which Vehicle is More Suited for You? "
Follow-up comment rss or Leave a TrackbackI have a degree in mechanical engineering and I worked for a major oil company for 35 years. They paid me just as well as they did the petroleum engineers. In fact I was so well paid that I retired before I was 60 years old. I also had a really interesting, challenging and rewarding career.
It really isn't the degree you have that determines your success but doing what you enjoy and how you apply yourself to the opportunities you have.
No… not unless you meet the requirements of the new degree program.. It may take an extra year of schooling – maybe more.
You need to check with the Petroleum Engineering department to see what the requirements are – THEN you must look at the course offerings and see if you can take the necessary courses in a reasonable time.
It may take two years to accomplish.
Texas Tech has an excellent PE school as well as a great Petroleum Geology program….one of our professors pretty much wrote the book on well logs…hes world renown…his name is Dr.George Asquith.
Yes you can specialize in petroleum with a chem eng degree. Some schools also have petroleum engineering course.
It won't be replaced soon, don't worry.
But even if it was replaced by next year by some unknown fuel source, petroleum is still used in giant quantities to make rubber, plastics, detergents, fertilizer and endless other chemicals.
I don't know what you would call a "top engineering school" but there are certainly a lot of chemical engineers working for oil companies in the area that a petroleum engineer would normally work.
Many don't come from the "top schools" but rather from the "good" schools that produce the majority of engineers who are the back bone of the US economy.
The truth is the "top schools" really don't produce any better engineers than the "good" schools. When it comes to actual application of engineering principles, it is the ability to reason, organize and think logically that gets the work done and that is really independent of the school you graduate from.
My definition of a "good" school is most of the state universities that have an accredited engineering school.
If what your looking for is hands on all the way it may be difficult to find an online class but if it just learning A, B, and C in your head it very possible that the degree can be gotten online sorry I can't help out much.
If you have the oil industry in mind for ChE as well. . . I'd go for any major colleges in the part the country where they actually have oil. You have a lot better access to what goes on in the real world that way.
I did my ChE BS in a non-oil area. . . I have a ton of college friends who are working in TX now for the oil companies (not my interest, though), so it's not that you don't learn what you need to know elsewhere. It's just a bit more frustrating if you can't see it, you know?
You do need to be prepared for a good challenge. I can confirm that at least ChE is NOT something you can slack off and still get a degree in — I worked harder with a 12-hour schedule than some other engineering majors did with 14-16+. I never met anyone in my school's petroleum program to ask how it was. . . tiny, tiny major. I'd expect there will always be a demand for both fields, although I'd be inclined to think the long-term (career-length, perhaps) outlook is better for ChE since you're less tied to these fossil fuels we're trying to cut down on using. Both seem to pay really well (#1 and #2 for starting salaries at my undergrad engineering school), although I hope you're not letting that dictate your career choices — you may go insane after 2-3 years if so.
There is a lot of work left to be done and (relatively speaking) there are not that many PE grads every year that are able to do it. Of course the industry is cyclical (I know this since I graduated in 1998 with very low oil prices). I did manage to find a job and it was been a very rewarding career.
Also – you can't beat the starting salaries coming out of school. This year the average is in the $90,000-100,000 range with about a $25,000 signing bonus. Not too shabby.
West Virginia University has an excellent engineering college that is recognized around the world for it's Petroleum and Mining Engineering degrees. When I went to school there (for Aerospace Engineering), it was very common to even have countries from the middle east send students there to learn how to do things right.
It is also a great school, beautiful and a lot of fun to go to.
The oil market will be fine for the next few years, but I would not be surprised if the job market for petroleum and pharmacy starts to get much more competitive.
There is still plenty of oil, but be warned.. petroleum is not exactly a walk in the park. I know a few people at UT Austin in petroleum who absolutely hated it and decided to switch either to business or a different engineering field. If you do not have an interest in the topics studied in petroleum then you will hate it, even if your job years down the line does pay well.
Oil and oil refinement are not going away in our lifetimes, petroleum is necessary for many precursors like plastics and many synthetic chemicals.
If you are still 2-3 years from starting your BS than keep an open mind and do your research. Alternative energy is definitely going to grow as well, so that might be an option too (not sure how that fits in degree-wise, but it is an emergent field)
As for trends in a few decades, obviously no one can say for sure, but petroleum is gonna be involved one way or another ^_^
I believe the petroleum engineering is more based on refinery operations and the oil and gas is a field engineer working on oil and gas production from the ground or ocean
If you disregard University of Texas at Austin and Texas A&M, then the best colleges for Petroleum Engineering are:
Stanford University (CA)
Colorado School of Mines
University of Oklahoma
Louisiana State University–Baton Rouge
University of Tulsa (OK)
Texas Tech University
Penn State University–University Park
New Mexico Institute of Mining and Technology
If you desire to be an engineer, one would think you would have the skills and knowledge to navigate to the University of Illinois, Champaign-Urbana website on your own.
You could use that degree as a start to then earn a Petroleum Engineering degree from the University of Houston, A&M, University of Texas or Texas Tech. They all offer both BS and MS degrees in Petroleum Engineering. The University of Houston just started their PE program in 2009 whereas the other 3 Texas schools have well established PE programs.
If your grades are good you should have no problem transferring to a 4-year program. You might lose some credit hours due to the differences in curriculum between Petroleum Tech and Petroleum Engineering. However, I have seen some of the Petroleum Tech programs which provided about 80% of similar classes as Petroleum Engineering during the first 2 years.
The easiest way to find out is to contact the University of Houston and discuss this with them as to what will transfer and what will not.
Info on Texas A&M program is available on the website. Also is an email where you can ask this question directly
Leave A Reply